It takes about a minute for the myTV app to 'find' your Cordcutter TV so if you don't see Cordcutter TV Setup, you haven't waited long enough. In the myTV app, go to Settings -> Cordcutter TV Setup -> Setup WiFi. 3- Open the myTV app on your phone or tablet.This will make a direct (adhoc) connection between your Cordcutter TV and the phone/tablet. Under Networks (on the iPhone you will see Other Networks) you should see a device named CordcutterTV_. On your phone or tablet, go to the WiFi Settings. 2- Connect Cordcutter TV to your phone or tablet.It takes about 30 seconds for Cordcutter TV to enter Setup mode. Hold the reset button depressed for 10 seconds while the power is plugged in. Unplug the power cable, push and hold the reset button while you plug in the power cord.
HD TV TUNER FOR MAC UPDATE
If you do not see the three downloads in the Firmware Update page, you did not hold the reset button long enough to go into Setup mode. To check that you have the correct firmware, open the myTV app, go to Settings -> Hauppauge Cordcutter TV -> Info and look for the firmware version. Now remove the power connector on the back of Cordcutter TV, remove the Ethernet cable from the Cordcutter TV, and then plug the power back into Cordcutter TV.
HD TV TUNER FOR MAC PC
The PC can be connected wired or wireless to your router.
You can use any Ethernet port on the back of the router except the port which is used to connect to the Internet (most times, this port is marked WAN, so don't use this one). Attach an Ethernet cable from your router to the Cordcutter TV.The yyyyy and zzzzz are the specific version numbers. You can find the Cordcutter TV Firmware file above.
HD TV TUNER FOR MAC DOWNLOAD
First, download the Cordcutter TV firmware files and unzip them.The following instructions assumes you have the Ethernet cable connecting your Cordcutter TV to the router. While you can either use Ethernet from the Cordcutter TV to the router, or Ethernet from the router to the PC, the easiest setup is if you connect your Cordcutter TV to the router with an Ethernet cable. Note: when updating the Cordcutter TV firmware, you will need a PC with a web browser and an Ethernet cable.